![]() ![]() The best advice I can give you is, invest a little time and patience, and learn to operate the scanner native software. Third party software, which is often buggy and/or badly work with the different scanners (not to mention rare exotica like yours) won't solve your problems. #PHOTOLINE MAKE BLACK AND WHITE SOFTWARE#A bad scan corrected later in Photoshop is not the same as an optimised via the scanning software pre-scan one can never get the same results in PS because a bad scan and a good scan do not contain the same data in the first place.Įach scanner brand utilize different software, and I as a Konica Minolta user can't give you a step by step tutorial, I believe only an experienced Imacon user can provide that.Īnd last but hardly the least, usually the native scanner software gives the best results - I know that from my own experience with KM I've heard the same from several Nikon scanner users and I have little doubt that a company of the stature of Hasselblad with a mythic scanner like Flextight did bundle the thing with an equally impressive and mighty software. Sorry for the bad news, but you must learn to use your scanning software to extract the best from your negatives/slides. If there is no good gray spot, then adjust the center point of the curve for the relevant channel to get the color balance right. Adjusting how much white and black is used in the mixture can help you make gray lighter or darker. So a combination of black and white creates gray. A mix between black and white would be a darker white or a lighter black, depending on how you look at it. If there is a good gray spot in the image use the "gray" eyedropper to click on it to adjust color balance. White is mixed with colors to lighten them, while black is used to darken them. ![]() įor each color channel, set the "white" and "black" points on the input (horizontal) scale to match the right and left edges of the histogram for that color. Īfter scanning, I use the curves tool in Photoshop to adjust the red. If you have a pre-scan mode use it to adjust exposure and cropping. I found the following process effective for many different slides and negatives. If you are scanning a variety of old slides (as I am), it is difficult to calibrate your system for products that no longer exist. Convert an image to black and white with a few easy clicks Highlight the light, contrast, and simple beauty of your photos by converting them into black-and-white images. The responses so far offer different ways to accomplish this. If you are scanning new slides and sticking to one or two types of film, then it is definitely worth calibrating your system for the film that you use. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |